Kia Picanto: Airbag Module / Side Airbag (SAB) Module
Description and operation
The
Side Airbags (SAB) are installed inside the front seat and protects the
driver and passenger from danger when side crash occurs. The SRSCM
determines deployment of side airbag by using Side Impact Sensor (SIS)
signal.
Never
attempt to measure the circuit resistance of the airbag module (squib)
even if you are using the specified tester. If the circuit resistance is
measured with a tester, accidental airbag deployment will result in
serious personal injury. |
Components and components location

Repair procedures
1. | Disconnect the battery negative terminal. After disconnecting the cables, wait at least 30 seconds. |
|
2. | Remove the seat back cover.
(Refer to Body -"Front seat back cover")
Improper
mounting of the front seat back cover, so interfering with the normal
deployment of side airbags and front seat backrest ensure that the cover
is well seated. |
|
3. | Loosen the side airbag module nuts and then remove the airbag module (A).
Tightening torque :
6.0 - 8.0 N.m (0.6 - 0.8 kgf.m, 4.4 - 5.9 lb-ft) |
 |
4. | Install in the reverse order of removal. |
Description and operation
Description
The
passenger airbag (PAB) is installed inside the crash pad and protects
the front passenger in the event of a frontal crash. The SRSCM
determines if ...
Description and operation
Description
Curtain
airbags are installed inside the headliner (LH and RH) and protect the
driver and passenger from danger when side crash occurs. The SRSCM
dete ...
Other information:
Repair procedures
Removal
1.Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.Drain the coolant.
(Refer to Cooling System - "Coolant")
3.Disconnect the oil cooler coolant hoses (A).
4.Remove the ...
Specifications
Specification
Item
Specification
Coil Resistance (Ω) 0.54 [20°C(68°F)] Pin 2 Peak Current (A) 5.3 Holding Current (A) 2.68 High Pressure Fuel Pressure bar 20 - 200 MPa 2 - 20 kgf/cm² 20.4 - 203.9 psi ...