Kia Picanto: Rear Door / Rear Door Power Window Regulator
Components and components location

Repair procedures
Put on gloves to protect your hands. |
•
| Use a plastic panel removal tool to remove interior trim pieces without marring the surface. |
•
| Be careful not to bend or scratch the trim and panels. |
|
1. | Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
|
2. | Disconnect the rear door power window motor connector (A).
 |
3. | Loosen the rear door power window regulator mounting nuts.
Tightening torque :
3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft) |
 |
4. | Remove the rear door power window regulator (A).
 |
5. | Install in the reverse order of removal. •
| Check that glass operation is normal. |
•
| Check the damage glass channel, and replace if necessary. |
•
| Adjust glass if necessary. |
|
|
Components and components location
Component Location
1. Rear door window glass
Repair procedures
Replacement
Put on gloves to protect your hands.
...
Components and components location
Component Location
1. Rear door outside handle
Repair procedures
Replacement
Put on gloves to protect your hands. ...
Other information:
Repair procedures
Removal and Installation
1.Remove the engine room under cover and RH side cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
3.Remove the RH s ...
Components and components location
Components
Repair procedures
Removal
1.Remove the brake fluid level sensor connector.
2.Remove the brake fluid from the master cylinder reservoir with a syringe.
Do
not spill brake fluid on the vehicle as it may dam ...