Kia Picanto: Rear Door / Rear Door Outside Handle

Kia Picanto JA 2017-2025 Service & Repair Manual / Body (Interior and Exterior) / Rear Door / Rear Door Outside Handle

Components and components location

Component Location

1. Rear door outside handle

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

Remove the rear door outside handle cover (A) after loosening the mounting bolt.

Tightening torque :

3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft)

2.	Remove the rear door outside handle (A) by sliding it rearward.

Install in the reverse order of removal.

•	Be sure to install the outside handle pad (A) between the outside handle and the door panel.

•	Make sure that the connector is connected properly.

•	Make sure that the door locks/unlocks and opens/closes properly.

Rear Door Power Window Regulator

Components and components location Component Location 1. Rear door module Repair procedures Replacement Put on gloves to protect your hands. ...

Rear Door Latch

Components and components location Component Location 1. Rear door latch Repair procedures Replacement Put on gloves to protect your hands. ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Rear Glass Defogger Switch

Repair procedures Inspection 1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).The diagnostic system (KDS/GDS) provides the following information.(1)Self diagnosis : Checking failure and code number (DTC)(2) Current data : Checki ...

Kia Picanto JA 2017-2025 Owner's Manual: Manual heating and air conditioning

The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected. When pressing any button (or turning any knob) except the AUTO button while using automatic op ...