Kia Picanto: Rear Bumper / Rear Bumper Assembly
Components and components location

Repair procedures
Put on gloves to protect your hands. |
•
| Use a plastic panel removal tool to remove interior trim pieces without marring the surface. |
•
| Be careful not to bend or scratch the trim and panels. |
|
1. | Separate the rear combination lamp (A) after loosening the mounting screws.
 |
2. | Disconnect the watherproof seal (A).
 |
3. | Disconnect the rear combination lamp connector (A).
 |
4. | Loosen the rear bumper upper mounting fastener.
 |
5. | Remove the rear bumper side after loosening the mounting screws.
 |
6. | Detach the rubber hangers (A) from the muffler (B).

 |
7. | Loosen the rear bumper lower mounting bolts.
[LH]

[RH]
 |
8. | Disconnect the rear bumper wiring connector (A).
 |
9. | Remove the rear bumper assembly (A).
 |
10. | Install in the reverse order of removal. •
| Make sure that the connector is plugged in properly. |
•
| Replace any damaged clips. |
|
|
Components and components location
Components
11. Rear bumper cover assembly 2. Rear bumper beam 3. Rear bumper side mounting bracket [LH]
...
Components and components location
Component Location
1. Rear bumper beam assembly
Repair procedures
Replacement
Put on gloves to protect your h ...
Other information:
Components and components location
Components
1. Left Remote Control Switch (Audio + Hands free + Voice) 2. Right Remote Control Switch (Cruise+Trip Computer)
Schematic diagrams
Circuit Diagram
[Audio]
[Audio + Bluetooth]
[Audio + Bluetooth + Voice]
...
Repair procedures
Removal and Installation
1.Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
3.Remove the drive belt tensioner ( ...