Kia Picanto (JA): Power Door Locks / Power Door Lock Switch
Repair procedures
| Inspection |
| 1. | Check for continuity between the terminals. If there is an abnormality, replace the switch.
|
| Removal |
|
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the front left door trim.
(Refer to Body - "Front Door Trim")
|
| 3. | Remove the power window switch assembly (A) by pulling out both ends of the switch holders (B).
|
| Installation |
| 1. | Install the driver power window switch. |
| 2. | Install the front door trim after connecting the connector. |
| 3. | Connect the negative (-) battery terminal. |
Components and components location Components 1. Door lock/unlock knob cable 2. Door inside handle cable 3. Door latch assembly Repair procedures Inspection • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Components and components location Component Location 1. Power door mirror 2. Power door mirror switch 3. Power folding mirror switch
Other information:
Kia Picanto (JA) 2017-2025 Service & Repair Manual: Antenna Coil
Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the steering column upper and lower shroud panel. (Refer to Body - "Steering Column Shroud Panel") 4.
Kia Picanto (JA) 2017-2025 Service & Repair Manual: Rear Glass Defogger Printed Heater
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Suspension System
- Body Control Module (BCM)
- Battery
- New on site
- Most important about car
