Kia Picanto: Lubrication System / Oil Pressure Switch

Kia Picanto JA 2017-2025 Service & Repair Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch

Repair procedures

Removal and Installation

1.	Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

Remove the oil pressure switch (B) after disconnecting the connector (A).

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.7 - 8.6 lb·ft)

Install in the reverse order of removal.

When installing the oil pressure switch, apply seal lock to the thread.

Seal lock : THREEBOND 2403

Thickness : 0.2 - 0.4 mm (0.008 - 0.016 in)

Inspection

1.	Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.

2.	Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.

3.	If there is no continuity when a 49.0 kPa (0.5 kg/cm², 7.1 psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Engine Oil

Flow diagram Flow Diagram Repair procedures Engine Oil And Filter Replacement • Prolonged and repeated contact with min ...

Oil Pan

Repair procedures Removal 1.Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - “Engine Room Under Cover”) 2.Drain the engine oil. (Refe ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Instrument panel overview

1. Instrument cluster 2. Horn 3. Driver’s front air bag 4. Light control/Turn signals 5. Wiper/Washer 6. Ignition switch ENGINE START/STOP button 7. Steering wheel audio control 8. LCD window control Cruise control Speed limit control 9. Hazard warning flasher switch 10. ...

Kia Picanto JA 2017-2025 Owner's Manual: Rocking the vehicle

If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth between 1st (First) and R (Reverse) in vehicles equipped with a manual transaxle or R (Reverse) ...