Kia Picanto (JA): Sunroof / Tilting the sunroof

To open the sunroof, push the sunroof control lever upward until the sunroof moves to the desired position.

To close the sunroof, push the sunroof lever forward until the sunroof moves to the desired position.

WARNING

  • Make sure heads, other body parts or other objects are safely out of the way before closing the sunroof to avoid injuries or vehicle damage.
  • Never adjust the sunroof or sunshade while driving. This may cause loss of vehicle control resulting in an accident.
  • To avoid serious injury or death, do not extend your head, arms or body outside the sunroof while driving.

CAUTION

  • Periodically remove any dirt that may accumulate on the guide rail.
  • If you try to open the sunroof when the temperature is below freezing or when the sunroof is covered with snow or ice, the glass or the motor could be damaged.
  • While using sunroof for a long time, a dust between sunroof and roof panel can make a noise. Open the sunroof and remove regularly the dust using clean cloth.
  • The sunroof is made to slide together with sunshade. Do not leave the sunshade closed while the sunroof is open.

    To open the sunroof, push the sunroof control lever backward. To close the sunroof, push the sunroof control lever forward. To open the sunroof automatically: Pull the sunroof control lever backward fully and then release it.

    Sunshade The sunshade will be opened with the glass panel automatically when the glass panel is slid. You will have to close it manually if you want it closed.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Wiper Motor

    Repair procedures Inspection Rear Wiper Motor 1.Remove the connector from the rear wiper motor. 2.Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. 3.Check that the motor operates normally.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Heater & A/C Control Unit(Full Automatic)

    Components and components location Components Control Panel Connector pin function No. Connector A Connector B 1 Battery PAB IGN1 2 ISG Battery (+) PAB On signal 3 Illumination (+) PAB Off signal 4 Sensor REF (+5V) - 5 Mode control actua

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0222