Kia Picanto (JA): Steering wheel / Heated Steering wheel

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Steering System / Steering wheel / Heated Steering wheel

Description and operation

Description

The heated steering wheel system improves the thermal comfort of the driver by heating the steering wheel when manually selected.

1.	Heated control unit

2.	Heated pad

Specifications

Item	Specification
Voltage	13.5 V ± 0.1V, 80W±10%
Heated pad resistance	1.85 ± 0.2 Ω (at 22°C ±1°C)
NTC resistance	10.0 kΩ ± 3% (at 23 - 27°C)

Schematic diagrams

System Circuit Diagram

Harness Connector

Terminal Function

Housing	Pin	Function	Wire color
Pad	A	GND	Black
	B	HEATER	Yellow
	C	NTC+	Black / Red
	D	NTC¯	Black

Repair procedures

Inspection

1.	Measure a resistance of NTC and Heated pad. NTC resistance (Black / Red, Black) : 10.0 kΩ ± 3% (at 23 - 27°C) Heated pad resistance (Yellow) : 1.85 ± 0.2 Ω (at 22°C ±1°C)

Measure a temperature.

–	The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute

–	The temperature of wheel surface grip must keep 38°C after 25 minute

❮Steering wheel

Components and components location Components 1. Bezel 2. Lower cover 3. Steering wheel 4. Remote switch 5. Wiring 6. Heated steering control unit Repair procedures Removal 1.

Motor Driven Power Steering❯

Description and operation Description MDPS (Motor Driven Power Steering) system uses an electric motor to assist the steering force and it is an engine operation independent steering system.

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Multifunction Switch

Specifications Specifications Items Specifications Rated voltage DC 12 V Operating temperature range -22 - 176°F (-30 - 80°C) Rated load Washer Washer : 6A (Motor load) Components and components location Component 1 .

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.