Kia Picanto JA: Audio system / Antenna

Kia Picanto (JA) 2017-{YEAR} Owner's Manual / Audio system / Antenna

Roof antenna

Your car uses a roof antenna to receive both AM and FM broadcast signals. This antenna is a removable type.

To remove the antenna, turn it counterclockwise. To install the antenna, turn it clockwise.

CAUTION

Before entering a place with a low height clearance or a car wash, remove surely the antenna by rotating it counter-clockwise. If not, the antenna may be damaged.
When reinstalling your antenna, it is important that it is fully tightened and adjusted to the upright position to ensure proper reception. But it could be folded or removed when parking the vehicle or when loading cargo on the roof rack.
When cargo is loaded on the roof rack, do not place the cargo near the antenna pole to ensure proper reception.

You can use the AUX port to connect audio devices and the USB port to plug in a USB device or iPod®. NOTICE When using a portable audio device connected to the power outlet, noise may occur during playback...

Other information:

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Control Shaft Complete

Components and components location Components Location 1. Control shaft complete Repair procedures Removal 1.Shift the gear to "neutral". 2.Remove the battery and battery tray. G 1.0 T-GDI KAPPA (Refer to Engine Electrical System - "Battery") 3...

Kia Picanto (JA) 2017-2025 Service & Repair Manual: Multimedia Jack

Schematic diagrams Circuit Diagram Description and operation Description The multimedia jack on the console upper cover is for customers who like to listen to external portable music players like the MP3 etc., through the vehicle's sound system when it is linked to this jack...

Categories

Windshield defrosting and defogging

WARNING

Windshield heating

Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the position and fan speed control knob or button to the lower speed.

For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed. If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position. Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows. Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.