Kia Picanto (JA): Hood / Hood Latch Release Handle

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle

Components and components location

Component Location

1. Hood latch release handle


Repair procedures

Replacement
1.
Using a remover, remove the hood release handle (A).

2.
Install in the reverse order of removal.
   
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.

    Repair procedures Replacement 1. Remove the hood weatherstrip (A).    Be careful not to damage the hood and body. 2. Install in the reverse order of removal.

    Components and components location Component Location 1. Hood lower latch assembly Repair procedures Replacement 1. Disconnect the hood latch connector (A).

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Parking Assist System

    Specifications Specification Item Specification Ultrasonic sensor Voltage rating DC 12V Detecting range 11.8 - 39.3 in (30 - 100 cm) Operation voltage DC 9 - 16 V Operation current 60mA Max.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Blower Resistor (Manual)

    Repair procedures Inspection 1.Measure terminal - to - terminal resistance of blower resistor. 2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0315