Kia Picanto: Crash Pad / Glove Box Housing

Kia Picanto JA 2017-2025 Service & Repair Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing

Components and components location

Component Location

1. Glove box housing assembly

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the crash pad side cover [RH] (A) by using a remover.

2.	Remove the glove box stopper (A) from the crash pad.

3.	Remove the glove box (A).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Crash Pad Lower Panel

Components and components location Component Location 1. Crash pad lower panel Repair procedures Replacement Put on gloves to protect your hands. ...

Steering Column Shroud Panel

Components and components location Component Location 1. Steering column shroud upper panel 2. Steering column shroud lower panel Repair procedures Replacement ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Water Temperature Control Assembly

Repair procedures Removal 1.Disconnect the battery negative terminal. 2.Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 3.Drain the coolant. (Refer to Cooling System - "Coolant") 4.Disconnect the ra ...

Kia Picanto JA 2017-2025 Owner's Manual: Distributing the sealant

12. Immediately drive approximately 7~10 km (4~6 miles or, about 10 min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 miles). If possible, do not fall below a speed of 20 km/h (12 miles). While driving, if you experience any unusual vib ...