Kia Picanto: Front Door / Front Door Latch

Kia Picanto JA 2017-2025 Service & Repair Manual / Body (Interior and Exterior) / Front Door / Front Door Latch

Components and components location
Component Location

1. Front door latch


Repair procedures
Replacement
   
Put on gloves to protect your hands.
   
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the door trim mounting braket (A) after loosening the screws.

3.
Disconnect the front door speaker connector (A), and then remove the wiring mounting clips.

4.
Remove the front door trim seal (A).

5.
Disconnect the door lock rod (A).

6.
Disconnect the door latch rod (A).

7.
Loosen the front door latch mounting screws (A).
Tightening torque :
Screw : 7.8 - 10.8 N·m (0.8 - 1.1 kgf·m, 5.8 - 8.0 lb·ft)

8.
Remove the front door latch (A) after disconnecting the latch connector(B).

9.
Install in the reverse order of removal.
   
Check that glass operation is normal.
Check the damage glass channel, and replace if necessary.
Adjust glass if necessary.
Front Door Outside Handle
Components and components location Component Location 1. Front door outside handle Repair procedures Replacement    Put on gloves to protect your ha ...

Front Door Belt Inside Weatherstrip
Repair procedures Replacement 1.Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2.Remove the front door belt inside weatherstrip (A). 3.Install in th ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Vacuum Pump


Repair procedures Removal and Installation 1.Disconnect the battery negative terminal. 2.Disconnect the wiring connectors and harness clamps and remove the connector brackets around the vacuum pump. 3.Remove the air cleaner assembly. (Refer to Intake and Exhaust System - "Air C ...

Kia Picanto JA 2017-2025 Service & Repair Manual: Fuel Filter


Repair procedures Removal 1.Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2.Disconnect the fuel pump motor connector (A) and fuel sender connector (B). 3.Disconnect the fuel feed tube quick-connector (A) after removing the fixing clip (B). 4.Rem ...

Copyright © www.kpicanto.com 2017-2025