Kia Picanto: Driving your vehicle / Cruise control system

Kia Picanto JA 2017-2023 Owner's Manual / Driving your vehicle / Cruise control system

The cruise control system allows you to program the vehicle to maintain a constant speed without pressing the accelerator pedal.

This system is designed to function above approximately 30 km/h (20 mph).

WARNING

CAUTION

During cruise-speed driving of a manual transaxle vehicle, do not shift into neutral without depressing the clutch pedal, since the engine will be over-revved. If this happens, depress the clutch pedal or release the cruise control ON-OFF switch.

NOTICE

During normal cruise control operation, when the SET switch is activated or reactivated after applying the brakes, the cruise control will energize after approximately 3 seconds. This delay is normal.

NOTICE

To activate cruise control, depress the brake pedal at least once after turning the ignition switch to the ON position or starting the engine. This is to check if the brake switch which is important part to cancel cruise control is in normal condition.

Good braking practices
WARNING Whenever leaving vehicle or parking, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the park position. Vehicles not fully engaged ...

Cruise control switch
O / CANCEL: Cancels cruise control operation. CRUISE / : Turns cruise control system on or off. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise contro ...

Other information:

Kia Picanto JA 2017-2023 Owner's Manual: Hood


Opening the hood 1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position for automatic transaxle and to the 1st(First) gear or R(Reverse) ...

Kia Picanto JA 2017-2023 Owner's Manual: Position lamp bulb replacement (Headlamp Type A)


1. Open the hood. 2. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly. 3. Remove the bulb from bulb-socket by pulling it out. 4. Insert a new bulb by inserting ...

Copyright © www.kpicanto.com 2017-2023