Kia Picanto (JA): Engine Control System / Boost Pressure Sensor (BPS)
Specifications
▷ Type: Piezo-resistive pressure sensor type
Pressure
[kPa (kg/cm² / psi)]
|
Output Voltage (V) [Vref=5V]
|
32.5 (0.33, 4.71)
| 0.5
|
284 (2.90, 41.19)
| 4.5
|
Description and operation
Installed
on the intercooler assembly, the Boost Pressure Sensor (BPS) measures
the pressure of the compressed air in turbocharger.
Schematic diagrams
Repair procedures
| 1. | Connect a KDS on the Data Link Connector (DLC). |
| 2. | Measure the output voltage of the BPS at idle and IG ON.
Pressure
[kPa (kg/cm² / psi)]
|
Output Voltage (V) [Vref=5V]
| 32.5 (0.33, 4.71)
| 0.5
| 284 (2.90, 41.19)
| 4.5
|
|
| 1. | Turn the ingnition switch OFF and disconnect the battery negative (-) terminal. |
| 2. | Disconnect the boost pressure sensor connector (A). |
| 3. | Remove the sensor by loosening the mounting bolts (B).
Boost pressure sensor mounting bolt :
6.9 - 10.8 N·m (0.7 - 1.1 kgf·m, 5.1 - 8.0 lb·ft) |
 |
| •
| Install the component to the specified torques. |
| •
| Note
that internal damage may occur when the component is dropped. If the
component has been dropped, inspect before installing. |
|
| 1. | Install in the reverse order of removal. |
Specifications
Specification
Temperature[⁰C(⁰F)]
Resistance(kΩ)
-40(-40) 811.
Specifications
Specification
▷ Type: Thermistor type
Temperature
Resistance (kΩ)
°C
°F
-40 -40 48.
Other information:
Repair procedures
Removal
1. Disconnect the negative (-) battery terminal.
2. Remove the license lamp assembly (A) after pressing the locking pin.
3. Disconnect the license lamp connector (A).
4. Remove the license lamp bulb (B) after removing the license lamp socket (A).
Components and components location
Component Location
1. Mode Control Actuator
Description and operation
Description
The mode control actuator is located at the heater unit. It
adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit.
