Kia Picanto: Auto Lighting Control System / Auto Light Sensor

Kia Picanto JA 2017-2024 Service & Repair Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor

Repair procedures
Inspection
Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor's input (illumination intensity) when the Auto Light Switch in Multi-Function Switch is turned ON, and the vehicle is in IGN1 or IGN2 ON Mode. If IGN1 = ON, BCM detects this voltage, and if the voltage exceeds rated voltage, then auto light failure occurs. (below 4V or above 6V)
   
Failure Occurrence: If auto light failure occurs, the head lamp must be turned ON regardless of sun light level. This is to prevent the head lamp from being turned OFF in case of auto light failure during night time.
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input.The auto light control doesn't work if the pin sunlight supply (5V regulated power from Ignition 1 power to sunlight sensor) is in short circuit with the ground.If IGN1 ON, The BCM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.This is designed to prevent any head lamp cut off when the failure occurs during the night.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto light sensor (A) from main crash pad.
3.
Disconnect the auto light sensor connector (B).

Installation
1.
Connect the auto light sensor connector.
2.
Install the auto light sensor.
3.
Connect the negative (-) battery terminal.
Auto Lighting Control System
Specifications Specifications Items Specifications Rated voltage 5V Load Max. 1mA (Relay load) Illuminations (LUX) 50 1.22 ± 0. ...

AVN System
Components and components location Component Location 1 . AVN head unit 2. Roof antenna (Radio+GPS/GNSS+DAB+GSM) 3. Multimedia jack 4 . Steering wheel remote control (SWRC) 5 . Hands-free m ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Glove Box Housing


Components and components location Component Location 1. Glove box housing assembly Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to r ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Tire (pressure & tread wear)


Repair procedures Inspection 1. Check the tire pressure. 13(inch) : 230 kPa (33 psi) 14(inch) : 230 kPa (33 psi) 15(inch) : 230 kPa (33 psi) 16(inch) : 230 kPa (33 psi) Tire Rotation Checking For Pull And Wander If the steering pulls to one side, rotate the tires according to the followi ...

Copyright © www.kpicanto.com 2017-2024