Kia Picanto: If you have a flat tire (with tire mobility kit) (Type B) / Using the Tire Mobility Kit

Kia Picanto JA 2017-2024 Owner's Manual / What to do in an emergency / If you have a flat tire (with tire mobility kit) (Type B) / Using the Tire Mobility Kit

1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.

Carefully follow below steps

2. Shake the sealant bottle.

3. Connect the filling hose (3) onto the connector of the sealant bottle (A).

4. Ensure that button (9) on the compressor is not pressed.

5. Unscrew the valve cap from the valve of the flat tire and screw filling hose (3) of the sealant bottle onto the valve.

6. Insert the sealant bottle into the housing (5) of the compressor so that the bottle is upright.

7. Ensure that the compressor is switched off, position 0.

CAUTION

Securely install the sealant filling hose to the valve. If not, sealant may flow backward, possibly clogging the filling hose.

8. Connect between compressor and the vehicle power outlet using the cable and connectors.

9. With the engine start/stop button position on or ignition switch position on, switch on the compressor and let it run for approximately 5~7 minutes to fill the sealant up to proper pressure. The inflation pressure of the tire after filling is unimportant and will be checked/corrected later.

Be careful not to overinflate the tire and stay away from the tire when filling it.

When the tire and wheel are damaged, do not use Tire Mobility Kit for your safety.

CAUTION

Tire pressure

Do not attempt to drive your vehicle if the tire pressure is below 230 kPa (33 psi). This could result in an accident due to sudden tire failure.

10. Switch off the compressor.

11. Detach the hose from the sealant bottle connector and from the tire valve.

Return the Tire Mobility Kit to its storage location in the vehicle.

WARNING

Carbon monoxide

Carbon monoxide poisoning and suffocation is possible if the engine is left running in a poorly ventilated or unventilated location (such as inside a building).

Components of the Tire Mobility Kit (TMK)
1. Speed restriction label 2. Sealant bottle and label with speed restriction 3. Filling hose from sealant bottle to wheel 4. Connectors and cable for the power outlet direct connection ...

Distributing the sealant
12. Immediately drive approximately 7~10 km (4~6 miles or, about 10 min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 miles). If possible, do ...

Other information:

Kia Picanto JA 2017-2024 Owner's Manual: Driving at night


Because night driving presents more hazards than driving in the daylight, here are some important tips to remember: Slow down and keep more distance between you and other vehicles, as it may be more difficult to see at night, especially in areas where there may not be any stree ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Rear Seat Back Cover


Components and components location Component Location 1. Rear seat back cover [RH] 2. Rear seat back cover [LH] Repair procedures Replacement    Put on gloves to protect your hands.    • Use ...

Copyright © www.kpicanto.com 2017-2024