Kia Picanto: If you have a flat tire (with tire mobility kit) (Type B) / Distributing the sealant

Kia Picanto JA 2017-2025 Owner's Manual / What to do in an emergency / If you have a flat tire (with tire mobility kit) (Type B) / Distributing the sealant

12. Immediately drive approximately 7~10 km (4~6 miles or, about 10 min) to evenly distribute the sealant in the tire.

CAUTION

Do not exceed a speed of 60 km/h (35 miles). If possible, do not fall below a speed of 20 km/h (12 miles). While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive with caution until you can safely pull off of the side of the road. Call for road side service or towing.

When you use the Tire Mobility Kit, the wheel may be stained by sealant. When you use the Tire Mobility Kit, the wheel may be stained by sealant. Therefore, remove the wheel stained by sealant and have the vehicle inspected at a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner.

Using the Tire Mobility Kit
1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to dri ...

Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location. 2. Connect the filling hose (3) of the compressor (clip mounted side) directly and then co ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Care of seat belts


Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse. WARNING When you return the rear seatback to its upright position after the rear seatba ...

Kia Picanto JA 2017-2025 Service & Repair Manual: Rear Oil Seal


Repair procedures Replacement 1.Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") 2.Remove the flywheel. (Refer to Cylinder Block Assembly - "Flywheel") 3.Remove the rear oil seal (A). 4.Using the SST (09214-0310 ...

Copyright © www.kpicanto.com 2017-2025