Kia Picanto: Light bulbs / Headlamp (Low/High beam) bulb
replacement (Headlamp Type A)

1. Open the hood.
2. Remove the headlamp bulb cover
by turning it counterclockwise.
3. Disconnect the headlamp bulb
socket-connector.
4. Unsnap the headlamp bulb retaining
wire by pressing the end and
pushing it upward.
5. Remove the bulb from the head
lamp assembly.
6. Install a new headlamp bulb and
snap the headlamp bulb retaining
wire into position by aligning the
wire with the groove on the bulb.
7. Connect the headlamp bulb socketconnector.
8. Install the headlamp bulb cover by
turning it clockwise.
Headlamp bulb

WARNING
Halogen bulbs
- Halogen bulbs contain pressurized
gas that will produce flying pieces
of glass if broken.
- Always handle them carefully, and
avoid scratches and abrasions. If
the bulbs are lit, avoid contact
with liquids. Never touch the glass
with bare hands. Residual oil may
cause the bulb to overheat and
burst when lit.
A bulb should be operated only
when installed in a headlight.
- If a bulb becomes damaged or
cracked, replace it immediately
and carefully dispose of it.
- Wear eye protection when changing
a bulb. Allow the bulb to cool
down before handling it.
1. Side repeater lamp (LED type)
2. Side repeater lamp (bulb type) ...
1. Open the hood.
2. Remove the bulb-socket from the
headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp ass ...
Other information:
The sensor is to maintain a certain distance
from the vehicle in front. However,
the smudged sensor with foreign
substances, such as snow and rain, adversely
affects the sensing performance.
It may even temporarily cancel
the AEB. Always keep the sensor clean.
Warning message and warn ...
Repair procedures
Removal and Installation
1.Disconnect the negative battery terminal.
2.Remove the engine room under cover and RH side cover.
(Refer to Engine and Transaxle Assembly - “Engine Room Under Cover”)
3.Drain the coolant.
(Refer to Cooling System - ...