Kia Picanto (JA): Maintenance / Light bulbs
- Bulb replacement precaution
- Light bulb position (Front)
- Light bulb position (Rear)
- Light bulb position (Side)
- Headlamp (Low/High beam) bulb replacement (Headlamp Type A)
- Position lamp bulb replacement (Headlamp Type A)
- Front turn signal lamp bulb replacement (Headlamp Type A)
- Headlamp (Low/High beam) bulb replacement (Headlamp Type B)
- Front turn signal lamp bulb (LED type) replacement
- Front fog lamp bulb replacement
- Position lamp + DRL (LED type) bulb replacement
- DRL (Bulb type) bulb replacement
- Side repeater lamp (LED type) bulb Replacement
- Side repeater lamp (bulb type) bulb Replacement
- Stop and tail lamp bulb replacement
- Rear turn signal lamp bulb replacement
- Stop and tail lamp (LED type) bulb replacement
- Back-up lamp bulb replacement
- Rear fog lamp bulb replacement
- High mounted stop lamp bulb replacement
- License plate lamp bulb replacement
- Map lamp bulb replacement
- Map lamp bulb replacement
- Vanity mirror lamp bulb replacement
- Room lamp bulb replacement
- Glove box lamp bulb replacement
- Tailgate room lamp bulb replacement
- Headlamp and front fog lamp aiming (for Europe)
Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. NOTICE Not all fuse panel descriptions in this manual may be applicable to your vehicle.
Please prepare bulbs with appropriate standards in case of emergencies. Refer to “Bulb Wattage” on page 9-04. When changing bulbs and sorts, first turn off the engine at a safe place, firmly apply the side brake and take out the battery's negative (-) terminal.
Other information:
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Ignition Switch Assembly
Repair procedures Inspection 1.Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column. 2.Check for continuity between the terminals. 3.If continuity is not specified, replace the switch.
Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Washer Switch
Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Engine Mechanical System
- Battery
- Engine Oil and Filter
- New on site
- Most important about car
