Kia Picanto: If you have a flat tire (with tire mobility kit) (Type A) / Using the Tire Mobility Kit

Kia Picanto JA 2017-2024 Owner's Manual / What to do in an emergency / If you have a flat tire (with tire mobility kit) (Type A) / Using the Tire Mobility Kit

1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast.

2. Filling the sealant Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.

3. Shake the sealant bottle.

4. Screw connection hose (10) onto the connector of the sealant bottle.

5. Ensure that screw cap (9) is closed.

6. Unscrew the valve cap from the valve of the flat tire and screw filling hose (3) of the sealant bottle onto the valve.

7. Insert the sealant bottle into the housing (5) of the compressor so that the bottle is upright.

8. Ensure that the compressor is switched off, position 0.

9. Connect between compressor and the vehicle power outlet using the cable and connectors.

NOTICE

Only use the front passenger side power outlet.

10. With the ignition switched on or engine start/stop button position on: Switch on the compressor and let it run for approximately 3 minutes to fill the sealant. The inflation pressure of the tire after filling is unimportant and will be checked/corrected later.

11. Switch off the compressor.

12. Detach the hose from the sealant bottle connector and from the tire valve.

Return the Tire Mobility Kit to its storage location in the vehicle.

WARNING

Carbon monoxide poisoning and suffocation is possible if the engine is left running in a poorly ventilated or unventilated location (such as inside a building).

Components of the Tire Mobility Kit (TMK)
1. Speed restriction label 2. Sealant bottle and label with speed restriction 3. Filling hose from sealant bottle to wheel 4. Connectors and cable for the power outlet direct connection ...

Distributing the sealant
13. Immediately drive approximately 7~10 km (4~6 miles or, about 10 min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 miles). If possible, do no ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Intake Air Temperature Sensor (IATS)


Specifications Specification ▷ Type: Thermistor type Temperature Resistance (kΩ) °C °F -40 -40 40.93 - 48.35 -30 -22 23.43 - 27.34 -20 -4 13.89 - 16.03 -10 14 ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Front Wheel Speed Sensor


Repair procedures Removal 1. Remove the wheel tire (A). Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) 2. Loosen the wheel speed sensor bracket bolts (A),(B) and then disconnect the wheel speed sensor connector (C). 3. Install ...

Copyright © www.kpicanto.com 2017-2024