Kia Picanto: Interior features / Seat warmer

The seat warmer is provided to warm
the front seats during cold weather.
With the ignition switch in the ON position,
push either of the switches to
warm the driver's seat or the front
passenger's seat.
During mild weather or under conditions
where the operation of the seat
warmer is not needed, keep the
switches in the “OFF” position.
• Each time you press the switch, the
temperature setting of the seat will
change as follows :
■ Front seat

• The seat warmer defaults to the OFF
position whenever the ignition switch
is turned on.
NOTICE
With the seat warmer switch in the
ON position, the heating system in
the seat turns off or on automatically
depending on the seat temperature.
CAUTION
- When cleaning the seats, do not
use an organic solvent such as
paint thinner, benzene, alcohol and
gasoline. Doing so may damage
the surface of the heater or seats.
- To prevent overheating the seat
warmer, do not place anything on
the seats that insulates against
heat, such as blankets, cushions or
seat covers while the seat warmer
is in operation.
- Do not place heavy or sharp objects
on seats equipped with seat
warmers. Damage to the seat
warming components could occur.
- Do not change the seat cover. It
may damage the seat warmer or
airventilation system.
WARNING
Seat warmer burns
Passengers should use extreme caution
when using seat warmers due
to the possibility of excess heating or burns. The seat warmer may
cause burns even at low temperatures,
especially if used for long periods
of time. In particular, the driver
must exercise extreme care for the
following types of passengers:
1. Infants, children, elderly or
handicapped persons, or hospital
outpatients
2. Persons with sensitive skin or
those that burn easily
3. Fatigued individuals
4. Intoxicated individuals
5. Individuals taking medication
that can cause drowsiness or
sleepiness (sleeping pills, cold
tablets, etc.)
Use the sunvisor to shield direct light
through the front or side windows.
To use the sunvisor, pull it downward.
To use the sunvisor for the side window,
pull it downward, unsnap it from
...
The power outlet is designed to provide
power for mobile telephones or other
devices designed to operate with vehicle
electrical systems. The devices
should draw less than 10 amps with
the ...
Other information:
Components and components location
Component Location
1. Front seat assembly
Repair procedures
Replacement
1. Loosen the front seat mounting bolts (A).
Tightening torque :
49.0 - 58.8 N·m (5.0 - 6.0 kgf·m, 36.2 - 43.4 lb·ft)
[Front]
...
Repair procedures
Removal
1.Disconnect the battery negative terminal.
2.Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
3.Drain the coolant.
(Refer to Cooling System - "Coolant")
4.Disconnect the ra ...