Kia Picanto: Seat Belt Pretensioner / Seat Belt Pretensioner (BPT)
Description and operation
The
Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH
& RH). When a vehicle crashes with a certain degree of frontal
impact, the pretensioner seat belt helps to reduce the severity of
injury to the front seat occupants by retracting the seat belt webbing.
This prevents the front occupants from thrusting forward and hitting the
steering wheel or the instrument panel when the vehicle crashes.
Never
attempt to measure the circuit resistance of the Seat Belt Pretensioner
(BPT) even if you are using the specified tester. If the circuit
resistance is measured with a tester, the pretensioner will be ignited
accidentally. This will result in serious personal injury. |
Components and components location

1. Seat Belt Pretensioner (BPT)
|
Repair procedures
1. | Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. |
2. | Remove the front anchor belt (A).
 |
3. | Remove the door scuff trim.
(Refer to Body - "Door Scuff Trim")
|
4. | Remove the center pillar trim.
(Refer to Body - "Center Pillar Trim)
|
5. | Loosen the seat belt pretensioner bolts (A,B).
Tightening torque
Bolt (A) : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft) Bolt (B) : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.7 lb-ft) |
 |
6. | Disconnect the seat belt pretensioner connector (A) and then remove the seat belt pretensioner.
 |
7. | Install in the reverse order of removal. |
Description and operation
Description
Driver
Anchor Pretensioner operates as well as Belt Pretensioner at the same
time If it gets into its deploy condition after a collision. It is
locate ...
Other information:
WARNING
Prior to working on the Interior
lamps, ensure that the “OFF” button
is depressed to avoid burning your
fingers or receiving an electric shock.
1. Using a flat-blade screwdriver, gently
pry the lens cover from lamp
housing.
2. Remove the bulb by pulling it
straight out.
...
Components and components location
Component Location
1. Hood assembly
Repair procedures
Replacement
Be careful not to damage the hood and body.
•
Work in a group of two when removing and instal ...