To defog inside windshield

1. Select any fan speed except “0” position.
2. Select desired temperature.
3. Select the
or
position.
4. The outside (fresh) air and air conditioning will be selected automatically.
If the air conditioning and outside (fresh) air position are not selected automatically, press the corresponding button manually.
To defrost outside windshield

1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot position.
3. Select the
position.
4. The outside (fresh) air and air conditioning will be selected automatically.
WARNING Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility.
To defog inside windshield 1. Set the fan speed to the desired position. 2. Select desired temperature. 3. Press the defrost button ( ). 4. The air conditioning will be turned on according to the detected ambient temperature and outside (fresh) air position will be selected automatically.
Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3.Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a bolt.
Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).