Kia Picanto: Body Electrical System / Horn
Components and components location

1. Horn switch 2. Horn relay
| 3. Horn 4. Clock spring
|
Repair procedures
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the engine room under cover.
G 1.0 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")
G 1.2 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")
|
3. | Remove the horn (A) after disconnecting the horn connector (B) and loosening the mounting the bolt.
 |
1. | Install the horn after connecting the horn connector. |
2. | Install the engine room under cover. |
3. | Connect the negative (-) battery terminal. |
1. | The relay on the horn of this vehicle is built into the engine room relay block. |
Schematic diagrams
Circuit Diagram
Repair procedures
Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the crash pad lower panel.
(Refer to Body - "Cras ...
Repair procedures
Inspection
1.Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column.
2.Check for continuity between the terminals.
3 ...
Other information:
Components and components location
Components
[Roof Antenna (Radio)]
[Roof Antenna (Radio+GPS/GNSS+DAB+GSM)]
Repair procedures
Removal
Roof antenna
1.Disconnect the negative (-) battery terminal.
2.Remove the roof trim assembly.
(Refer to Body - "Ro ...
Repair procedures
Inspection
Check
the brake fluid level in the brake fluid reservoir. The level should be
between “MIN” and “MAX” marks on the side of the reservoir.
Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 specification.
Check the brake system for any le ...