Kia Picanto: Lighting / Headlight welcome function

Kia Picanto JA 2017-2024 Owner's Manual / Features of your vehicle / Lighting / Headlight welcome function

When the headlight switch is in the ON or AUTO position and all doors (and tailgate) are closed and locked, if you press the door unlock button on the transmitter (or smart key), the headlights will come on for about 15 seconds. If the headlight switch is in the AUTO position, the function can only operate at night.

At this time, if you press the door unlock button again or door lock button on the transmitter (or smart key), the headlights will turn off immediately.

NOTICE

Traffic change (for Europe)

The low beam light distribution is asymmetric. If you go abroad to a country with opposite traffic direction, this asymmetric part will dazzle oncoming car driver. To prevent dazzle, ECE regulation demand several technical solutions (ex. automatic change system, adhesive sheet, down aiming). This headlamps are designed not to dazzle opposite drivers. So, you need not change your headlamps in a country with opposite traffic direction.

Headlight escort function
The headlights (and/or taillights) will remain on for approximately 5 minutes after the ignition key is removed when the engine is turned off. However, if the driver’s door is opened and clo ...

Lighting control
The light switch has a Headlight and a Parking light position. To operate the lights, turn the knob at the end of the control lever to one of the following positions: 1. Off position 2. Aut ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Clutch Cable


Components and components location Components [Kappa 1.0 MPI / FFV, Kappa 1.2 MPI] 1. Clutch pedal assembly 2. Clutch cable Repair procedures Removal 1.Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Loosen the clutch cable adjust nut (A) and th ...

Kia Picanto JA 2017-2024 Service & Repair Manual: MDPS ECU


Repair procedures Replacement 1. Disconnect the battery negative cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel") 3. Disconnect the MDPS ECU connector. 4. Loosen the bolts and then remove the MDPS ECU. 5. Installation is the reverse of the re ...

Copyright © www.kpicanto.com 2017-2024