Kia Picanto: Light bulbs / Front turn signal lamp bulb
replacement (Headlamp Type A)

1. Open the hood.
2. Remove the bulb-socket from the
headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp assembly.
3. Remove the bulb from the bulbsocket
by pressing it in and rotating
it counterclockwise until the
tabs on the bulb align with the slots
in the bulb-socket. Pull the bulb out
of the bulb-socket.
4. Insert a new bulb by inserting it into
the bulb-socket and rotating it
until it locks into place.
5. Install the socket in the headlamp
assembly by aligning the tabs on
the bulb-socket with the slots in
the assembly. Push the bulb-socket
into the headlamp assembly and
turn the socket clockwise.
1. Open the hood.
2. Remove the bulb-socket from the
headlamp assembly by turning the
bulb-socket counterclockwise until
the tabs on the bulb-socket align
with the slots on the headlamp ass ...
1. Open the hood.
2. Remove the headlamp bulb cover
by turning it counterclockwise.
3. Disconnect the headlamp bulb
socket-connector.
4. Remove the bulb-socket from the
headlamp assembly by ...
Other information:
Repair procedures
Replacement
1. Disconnect the battery negative cable.
2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel")
3. Disconnect the MDPS ECU connector.
4. Loosen the bolts and then remove the MDPS ECU.
5. Installation is the reverse of the re ...
Operates as follows when the ignition
switch is turned ON.
1 2/HI : Fast wiper speed
2 1/LO : Normal wiper speed
3 ---/INT :
Wiper operates intermittently
at the same wiping
intervals. Use this mode in
light rain or mist. To vary
the speed setting, turn
the speed control knob.
4 ...