Kia Picanto: Front Seat Belt / Front Seat Belt Retractor
Components and components location

1. Front seat belt retractor
| |
Repair procedures
1. | Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
2. | Remove the front seat belt upper anchor (A) after loosening the mounting bolt.
Tightening torque :
39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft) |
 |
3. | Remove the front seat belt retractor (A) after loosening the bolts.
Tightening torque :
Lower : 39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft) Upper : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft) |
 |
4. | Disconnect the connector (A).
 |
5. | Install in the reverse order of removal. •
| Make sure that the connector is plugged in properly. |
•
| Replace any damaged clips. |
|
|
Components and components location
Components
1. Front seat belt retractor 2. Height adjuster 3. Rear seat belt retractor 4. Rear seat belt buckle
...
Components and components location
Component Location
1. Height Adjuster
Repair procedures
Replacement
1.Remove the front seat belt upper anchor.
(Refer to Front Se ...
Other information:
Repair procedures
Removal
1.Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
2.Disconnect the fuel pump motor connector (A) and fuel sender connector (B).
3.Disconnect the fuel feed tube quick-connector (A) after removing the fixing clip (B).
4.Rem ...
Refrigerant label
The refrigerant label is located on the
underside of the hood.
Declaration of conformity
The radio frequency components of the
vehicle comply with requirements and
other relevant provisions of Directive
1995/5/EC.
Further information including the manufacturer's
d ...