Kia Picanto: Power Train / Engine Oil and Filter

Kia Picanto JA 2017-2024 Service & Repair Manual / Maintenance / Power Train / Engine Oil and Filter

Repair procedures
Inspection
Engine Oil Level
   
Be sure that the vehicle is on level ground.
1.
Warm up and stop the engine, and then wait for 5 minutes.
2.
Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.
3.
Pull the dipstick out, wipe and re-insert it fully.
4.
Check that the oil level is between the "L" level mark and "F" level mark on the engine oil level gauge.
5.
If the level is low, check for leakage and add oil up to the full level mark.
   
Use a funnel to help prevent oil from being spilled on engine components.
   
Do not fill the engine with oil to above the full level mark.
Engine Oil Appearance
1.
Check engine oil for white turbidity or heavy contamination.
2.
If engine oil becomes turbid and white, it is highly probable that it is contaminated with engine coolant.
Repair or replace damaged parts.
Replacement
   
Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use water-less hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
In order to preserve the environment, used oil and used oil filter must be disposed of only at designated disposal sites.
1.
Park the car on level ground.
2.
Drain the engine oil.
(1)
Remove the oil filler cap.
(2)
Remove the oil drain plug (A) and drain the oil into a container.
[Kappa 1.0 MPI, 1.0 FFV]

[Kappa 1.2 MPI]

[Kappa 1.0 T-GDI]

3.
Replace the oil filter.
(1)
Using the SST (09263-02000), remove the oil filter (A).
(2)
Check and clean the oil filter installation surface.
(3)
Check that the part number of the new oil filter is the same as the previous one.
(4)
Apply clean engine oil to the gasket of a new oil filter.
(5)
Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(6)
Tighten it to the torque below.
Tightening torque :
11.8 - 15.7 N·m (1.2 - 1.6 kgf·m, 8.7 - 11.6 lb·ft)
[Kappa 1.0 MPI, 1.0 FFV]

[Kappa 1.2 MPI]

[Kappa 1.0 T-GDI]

4.
Install the oil drain plug with a new gasket.
Tightening torque :
34.3 - 44.1 N·m (3.5 - 4.5 kgf·m, 25.3 - 32.5 lb·ft)
5.
Fill with new engine oil, after removing the engine oil level gauge.
Capacity
[Kappa 1.0 MPI, 1.0 FFV]
Total :
3.2 L (0.84 U.S.gal., 3.38 U.S.qt., 2.81 lmp.qt.)
Oil pan :
2.7 L (0.71 U.S.gal., 2.85 U.S.qt., 2.37 lmp.qt.)
Drain and refill including oil filter :
2.9 L (0.77 U.S.gal., 3.06 U.S.qt., 2.55 lmp.qt.)
[Kappa 1.2 MPI]
Total :
3.55 L (0.94 U.S.gal., 3.75 U.S.qt., 3.12 lmp.qt.)
Oil pan :
3.3 L (0.87 U.S.gal., 3.49 U.S.qt., 2.90 lmp.qt.)
Drain and refill including oil filter :
3.5 L (0.92 U.S.gal., 3.70 U.S.qt., 3.08 lmp.qt.)
[Kappa 1.0 T-GDI]
Total :
3.9 L (1.03 U.S.gal., 4.12 US qt, 3.43 lmp qt)
Oil pan :
3.3 L (0.87 U.S.gal., 3.49 U.S.qt., 2.90 lmp.qt.)
Drain and refill including oil filter :
3.6 L (0.95 U.S.gal., 3.80 U.S.qt., 3.17 lmp.qt.)
6.
Install the oil filler cap.
7.
Start engine and check for oil leaks.
8.
Recheck the engine oil level.
9.
To reset the service interval to the recommended mileage, refer to the service mode section in the owner's manual for procedure (if applicable).
Drive Belt
Repair procedures Inspection 1.Check belt for maintenance and abnormal wear of V-ribbed part. Replace if necessary.    • Do not bend, twist or t ...

Exhaust System
Repair procedures Inspection 1. Visually check the pipes, hangers and connections for severe corrosion, leaks or damage. 2. Check for unusual exhaust sounds or abnormal exhaust fumes. ...

Other information:

Kia Picanto JA 2017-2024 Owner's Manual: Manual climate control system


To defog inside windshield 1. Select any fan speed except “0” position. 2. Select desired temperature. 3. Select the or position. 4. The outside (fresh) air and air conditioning will be selected automatically. If the air conditioning and outside (fresh) air position are not selecte ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Clutch switch


Specifications Specifications Item Specifications Working voltage DC 12.5V Operating force Initial position : 0.25 ± 0.15 N (0.025 ± 0.015 kg, 0.056 ± 0.034 lb) Full position : 0.8 ± 0.2 N (0.08 ± 0.02 kgf, 0.579 ± 0.0 ...

Copyright © www.kpicanto.com 2017-2024