Kia Picanto (JA): Body Side Molding / Delta Garnish

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Body (Interior and Exterior) / Body Side Molding / Delta Garnish

Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a remover, remove the delta garnish (A).

2.
Install in the reverse order of removal.
   
Replace any damaged clips.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Headlamp Leveling Switch

    Schematic diagrams Circuit Diagram Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the crash pad side switch (A) after loosening the mounting screws.

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Heater & A/C Control Unit(Manual)

    Components and components location Components [NON ISG] Connector pin function No. Connector A Connector B 1 Low Battery 2 Common Illumination (+) 3 Ground HTD 4 Middle (Low) ISG Battery 5 Middle (High) - 6 High Detent out (-) 7 - 8 Sen

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.026