Kia Picanto: Intake And Exhaust System / Air Cleaner

Kia Picanto JA 2017-2024 Service & Repair Manual / Engine Mechanical System / Intake And Exhaust System / Air Cleaner

Components and components location

Components

1. Air duct
2. Air cleaner assembly

3. Air intake hose

Repair procedures

Removal and Installation

Air Cleaner Assembly

Unfasten the air intake hose clamp (A).

Tightening torque :

2.9 - 4.9 N·m (0.3 - 0.5 kgf·m, 2.2 - 3.6 lb·ft)

Disconnect the air duct (B), and then remove the air cleaner assembly (C).

Tightening torque :

3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft)

3.	Disconnect the recirculation valve (RCV) hose (A) and breather hose (B).

Disconnect the air intake hose (C).

Tightening torque :

2.9 - 4.9 N·m (0.3 - 0.5 kgf·m, 2.2 - 3.6 lb·ft)

5.	Installation is reverse order of removal.

Air Cleaner Element Replacement

1.	Open the air cleaner element cover (A) by unlocking the clamp.

2.	Unlock the air cleaner element camshaft (A) by turning in the direction of arrow.

Replace the air cleaner element (A) with a new one.

Grab the handle (B) then pull out the air cleaner element.

4.	Close the service cover by hooking the clamp.

Inspection

1.	Remove the air cleaner element.

2.	Check if the air filter is excessively dirty. If so, replace the air cleaner element.

If the air cleaner element needs to be cleaned, blow compressed air as shown in the illustration to clean it.

Be fully aware of the direction of using compressed air on the air cleaner.

4.	Reinstall the air cleaner element.

Intake Manifold

Components and components location Components 1. Manifold absolute pressure sensor (MAPS) 2. Intake manifold 3. Electronic throttle body control (ETC) module gasket 4. Intake manifold gasket ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Flywheel

Repair procedures Removal and Installation 1.Remove the manual transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") 2.Remove the clutch cover. (Refer to Clutch System - "Clutch Cover and Disc") 3.Remove the flywheel (A). ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Ignition Switch Assembly

Repair procedures Inspection 1.Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column. 2.Check for continuity between the terminals. 3.If continuity is not specified, replace the switch. Removal 1.Disconnect the negative (-) batt ...