Kia Picanto: Cylinder Block Assembly / Flywheel

Kia Picanto JA 2017-2025 Service & Repair Manual / Engine Mechanical System / Cylinder Block Assembly / Flywheel

Repair procedures
Removal and Installation
1.
Remove the manual transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
Remove the clutch cover.
(Refer to Clutch System - "Clutch Cover and Disc")
3.
Remove the flywheel (A).
Tightening torque :
68.6 - 78.5 N·m (7.0 - 8.0 kgf·m, 50.6 - 57.9 lb·ft)

   
Do not reuse the flywheel bolts.
4.
Install in the reverse order of removal.
Cylinder Block Assembly
Components and components location Components 1. Water jacket insert 2. Water jacket insert inlet 3. Cylinder block 4. O-ring 5. Oil jet 6. Thrust bearing 7. Crankshaft upper main bearing 8. ...

Water Jacket Insert
Repair procedures Removal and Installation 1.Remove the cylinder head assembly. (Refer to Cylinder Head Assembly - "Cylinder Head") 2.Remove the water jacket insert inlet (A) ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Checking the brake/clutch fluid level


Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch fluid, clean the area around the reservoir cap thoroughly to prevent brake/clutch fluid cont ...

Kia Picanto JA 2017-2025 Owner's Manual: Good driving practices


Never take the vehicle out of gear and coast down a hill. This is extremely hazardous. Always leave the vehicle in gear. Don't "ride" the brakes. This can cause them to overheat and malfunction. Instead, when you are driving down a long hill, shift to a lower gear. When you ...

Copyright © www.kpicanto.com 2017-2025