Kia Picanto: ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor

Kia Picanto JA 2017-2025 Service & Repair Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor

Description and operation
Description
In order to ensure adequate brake power assistance in every situation, the brake booster is equipped with a partial vacuum sensor. The brake booster vacuum pressure sensor is located beside the brake booster.

Repair procedures
Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of vacuum hose.
2.
Connect KDS to DLC (Data Link Cable).
3.
Warm up the engine to normal operating temperature.
4.
Monitor "BBVPS" parameter on KDS.
Battery sensor
Description and operation Description Vehicles have many control units that consume electricity. Each unit controls its own system based on information from various sensors. Hence, a stabl ...

AGM Battery
Specifications Specification ▷ AGM50L-DIN Item Specification Capacity [20HR / 5HR] (AH) 50/40 Cold Cranking Amperage ( ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Checking the amount of air conditioner refrigerant and compressor lubricant


When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a bad influence on the air conditioning system. Therefore, if abnormal operation is found, have the system inspected by a professional workshop. Kia recommends to visit an aut ...

Kia Picanto JA 2017-2025 Service & Repair Manual: Blower Unit


Components and components location Component Location 1. Blower Unit Components 1. Intake Actuator 2. Intake Case [Lower] 3. Air Filter 4. FET 5. Resister 6. Intake Seal 7. Intake Case [Upper] 8. Intake Door Assembly 9. Anti Noise Pad 10. Air Filter Cover 11. Blower Case [Upper] 12. ...

Copyright © www.kpicanto.com 2017-2025