Kia Picanto: Wipers and washers / Windshield wipers (front)
Operates as follows when the ignition
switch is turned ON.
1 2/HI : Fast wiper speed
2 1/LO : Normal wiper speed
3 ---/INT :
Wiper operates intermittently
at the same wiping
intervals. Use this mode in
light rain or mist. To vary
the speed setting, turn
the speed control knob.
4 O/OFF : Wiper is not in operation
5 ˅/1X : For a single wiping cycle,
move the lever to this position
and release it. The
wipers will operate continuously
if the lever is held
in this position.
NOTICE
If there is heavy accumulation of
snow or ice on the windshield, defrost
the windshield for about
10 minutes, or until the snow and/or
ice is removed before using the
windshield wipers to ensure proper
operation. If you do not remove the
snow and/or ice before using the
wiper and washer, it may damage
the wiper and washer system.
A : Wiper speed control (front)
1. 2/HI – High wiper speed
2. 1/LO – Low wiper speed
3. ---/INT – Intermittent wipe
4. O/OFF – Off
5. /1X – Single wipe
B : Intermittent control w ...
In the O (Off) position, pull the lever
gently toward you to spray washer fluid
on the windshield and to run the wipers
1-3 cycles.
Use this function when the windshield
is dirty.
The spra ...
Other information:
Filter replacement
It must be replaced when necessary,
and should not be washed.
You can clean the filter when inspecting
the air cleaner element.
Clean the filter by using compressed
air.
1. Loosen the air cleaner cover attaching
clips and open the cover.
2. Unlock by turning t ...
Components and components location
Component Location
1. Rear center seat belt retractor
Repair procedures
Replacement
When installing the belt, be careful not to damage the retractor.
1.Remove the rear seat back dust cover.
(Refer t ...