Kia Picanto: Specifications & Consumer information / Vehicle Identification Number (VIN), Vehicle certification label

Kia Picanto JA 2017-2023 Owner's Manual / Specifications & Consumer information / Vehicle Identification Number (VIN), Vehicle certification label

Vehicle Identification Number (VIN)

The vehicle identification number (VIN) is the number used in registering your car and in all legal matters pertaining to its ownership, etc.

The number is punched on the floor under the right side seat. To check the number, remove the cover.

VIN label

The VIN is also on a plate attached to the top of the dashboard. The number on the plate can easily be seen through the windshield from outside.

Vehicle certification label

The vehicle certification label attached on the driver’s (or front passenger’s) side center pillar gives the vehicle identification number (VIN).

Recommended lubricants and capacities

To help achieve proper engine and powertrain performance and durability, use only lubricants of the proper quality. The correct lubricants also help promote engine efficiency that results in imp ...

Tire specification and pressure label, Engine number, Air conditioner compressor label

Tire specification and pressure label The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center ...

Other information:

Kia Picanto JA 2017-2023 Owner's Manual: How does the air bag system operate

Air bags are activated (able to inflate if necessary) only when the ignition switch is turned to the ON or START position. Air bags inflate instantly in the event of a serious frontal collision or side collision (if equipped with a side air bag or curtain air bag) in order to ...

Kia Picanto JA 2017-2023 Service & Repair Manual: Front Wheel Speed Sensor

Repair procedures Removal 1. Remove the wheel tire (A). Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) 2. Loosen the wheel speed sensor bracket bolts (A),(B) and then disconnect the wheel speed sensor connector (C). 3. Install ...