Kia Picanto: ISG (Idle Stop & Go) System / Seat belt switch

Kia Picanto JA 2017-2025 Service & Repair Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat belt switch

Components and components location

Component Location

1. Front seat belt buckle

Repair procedures

Replacement

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Disconnect the front seat belt wiring mounting clips (A).

Remove the front seat belt buckle (A) after loosening the mounting bolt.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.9 - 39.8 lb·ft)

Install in the reverse order of removal.

•	Make sure that the connector is plugged in properly.

•	Replace any damaged clips.

Door switch

Description and operation Description Via the seat belt/Door switch, the ISG function can detect that the driver has fastened the seat belt/door. If the driver has not fastened the seat be ...

Hood switch

Description and operation Description The hood switch is included as the influencing factors in the calculation of the ISG function. If the hood is open, the engine must not be started or ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Service Mode

Service in It calculates and displays when you need a scheduled maintenance service (mileage or days). If the remaining mileage or time reaches 1,500 km (900 mi.) or 30 days, “Service in” message is displayed for several seconds each time you set the ignition switch or Engine Start ...

Kia Picanto JA 2017-2025 Owner's Manual: Using the Tire Mobility Kit

1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. Carefully follow below steps 2. Shake the sealant bottle. 3. Connect the filling ...