Kia Picanto Manuals

Kia Picanto: Rear Suspension System / Rear Torsion Beam Axle

Kia Picanto JA 2017-2024 Service & Repair Manual / Suspension System / Rear Suspension System / Rear Torsion Beam Axle

Components and components location
Components
[Disc type]

1. Torsion beam axle
2. Brake disc
3. Brake caliper

[Drum type]

1. Torsion beam axle
2. Drum brake

Repair procedures
Replacement
1.
Switch "OFF" ignition and disconnect the negative (-) battery terminal.
2.
Remove the battery.
G 1.0 MPI (Refer to Engine Electrical System - "Battery")
G 1.2 MPI (Refer to Engine Electrical System - "Battery")
3.
Remove the brake fluid level sensor connector

4.
Remove the brake fluid from the master cylinder reservoir with a syringe.
   
Do not spill brake fluid on the vehicle as it may damage the paint. If brake fluid comes in contact with the paint, wash off immediately with water.
5.
Remove the wheel tire (A).
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

   
Be careful not to damage the wheel nuts when removing the front wheel and tire.
6.
Remove the rear shock absorber cover.

7.
Remove the rear shock absorber cover.

8.
Remove the rear shock absorber nut by using the special tool (09546-3X100)
Tightening torque :
21.6 - 31.4 N·m (2.2 - 3.2 kgf·m, 15.9 - 23.1 lb·ft)

9.
Loosen the bolt and then remove the rear shock absorber.
Tightening torque:
98.0 - 117.6 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.7 lb·ft)

   
Set up the transmission jack under the torsion beam in order to remove the shock absorber in no-load condition.
10.
Remove the rear caliper.
(Refer to Brake System - "Rear Disc Brake")
(Refer to Brake System - "Rear Drum Brake")
11.
Remove the rear hub assembly.
(Refer to Driveshaft and axle - "Rear hub - Carrier")
12.
Remove the brake tube bracket bolt.

13.
Loosen the flaer nut (A) and hose clip (B) from the rear torsion beam axle.

14.
Loosen the rear torsion beam axle nut and then remove the torsion beam axle.
Tightening torque:
98.0 - 117.6 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.7 lb·ft)

15.
Install in the reverse order of removal.
16.
After installation, bleed the brake system.
(Refer to Brake system - "Brake System")
Rear Coil Spring
Repair procedures Replacement 1. Remove the wheel tire (A). Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)    Be ca ...

Tires/Wheels
...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Antenna


Components and components location Components [Roof Antenna (Radio)] [Roof Antenna (Radio+GPS/GNSS+DAB+GSM)] Repair procedures Removal Roof antenna 1.Disconnect the negative (-) battery terminal. 2.Remove the roof trim assembly. (Refer to Body - "Ro ...

Kia Picanto JA 2017-2024 Owner's Manual: Lighting


Battery saver function The purpose of this feature is to prevent the battery from being discharged. The system automatically turns off the parking lights when the driver removes the ignition key (smart key: turns off the engine) and opens the driver-side door. With this featu ...

Copyright © www.kpicanto.com 2017-2024