Kia Picanto: Lighting System / Map Lamp
Repair procedures
•
| Put on gloves to prevent hand injuries. |
•
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
|
1. | Disconnect the negative (-) battery terminal. |
2. | Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp.
|
3. | Remove the map lamp (A) after loosening the screws.
•
| When removing the map lamp, be careful of the direction in which the tool is inserted (B). |
•
| When inserting the tool in the opposite direction, take caution as the map lamp may be damaged. |
|
|
4. | Remove the map lamp assembly (B) after disconnecting the map lamp connector (A).
|
Bulb Replacement
1. | Using a screwdriver or remover, separate the map lamp lens (A) from the map lamp.
|
2. | Disconnect the map lamp bulb (A).
|
1. | Connect the map lamp connector. |
3. | Install the map lamp lens. |
4. | Connect the negative (-) battery terminal. |
Repair procedures
Removal
Door Mirror Turn Signal Lamp
1. Disconnect the negative (-) battery terminal.
2. Remove the mirror (A) from the mirror holder.
Be carefu ...
Repair procedures
Inspection
1.Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.
No.
...
Other information:
Follow either of these procedures:
Move the lever down (to SET-) and
hold it. Your vehicle will gradually
slow down. Release the lever at the
speed you want to maintain.
Move the lever down (to SET-) and
release it immediately. The cruising
speed will decrease by 2.0 km/h
( ...
Components and components location
Component Location
1. Rear door trim
Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior t ...