Kia Picanto: Wipers and washers / Heated washer nozzle

Kia Picanto JA 2017-2024 Owner's Manual / Features of your vehicle / Wipers and washers / Heated washer nozzle

The heated washer nozzle function defreeze the washer nozzles in freezing weather.

The heated washer nozzle will turn on and off automatically when the ignition switch is in ON or when the engine is running in following conditions:

- Turns ON when the outside temperature is below 5°C, and OFF when it is over 10°C.
- The washer fluid defreezing speed may be slower when the ignition is in ON, than compared to when the engine is running.
- When the ignition is in ON, after 20 minutes of operation, the system will turn off automatically to prevent possible battery discharge.
- After the engine is running, the washer fluid will defrost after 5 to 10 minutes.
- If the engine has been started within the operating temperature, the heated nozzle remains ON even after 20 minutes.

NOTICE

In below conditions, the heated washer nozzle may not function properly.

- The washer fluids in the washer reservoir is frozen.
- Outside temperature sensor is malfunctioning.

Windshield washers (front)
In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spra ...

Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer. 6. Rear window ...

Other information:

Kia Picanto JA 2017-2024 Owner's Manual: System operation


Ventilation 1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desired speed. Heating 1. Set the mode to the position. 2. Set the air intake con ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Positive Crankcase Ventilation (PCV) Valve


Description and operation Operation Principle Repair procedures Removal 1. Disconnect the vapor hose (A). 2. Remove the PCV valve (B). PCV valve : 1.89 - 2.84 N·m (0.19 - 0.29 kgf·m, 1.40 - 2.09 lb·ft) Inspection 1. Insert a thin stick ( ...

Copyright © www.kpicanto.com 2017-2024