Kia Picanto: Front Seat / Front Seat Assembly

Kia Picanto JA 2017-2024 Service & Repair Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly

Components and components location

Component Location

1. Front seat assembly

Repair procedures

Replacement

Loosen the front seat mounting bolts (A).

Tightening torque :

49.0 - 58.8 N·m (5.0 - 6.0 kgf·m, 36.2 - 43.4 lb·ft)

[Front]

[Rear]

2.	Disconnect the airbag connector (A), seat heater connector (B), front seat belt buckle connector (C). [Driver side] [Passenger side]

Install in the reverse order of removal.

SEAT MOUNTING BOLT INSTALLATION PROCEDURE

•	Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.

•	Set the seat into the foremost position. Check that each slide is locked, and then tighten the rear mounting bolt completely.

•	Set the seat into the rearmost position. Check that the front mounting bolt is tightened completely.

•	Check that the seat operates to and fro smoothy and the locking portion locks properly.

Front Seat

Components and components location Components 1. Front seat inner shield cover 2. Front seat headrest 3. Front seat back covering 4. Front seat armrest 5. Front seat back heater ...

Front Seat Shield Outer Cover

Components and components location Component Location 1. Front seat shield outer cover Repair procedures Replacement Put on gloves to protect your han ...

Other information:

Kia Picanto JA 2017-2024 Owner's Manual: Limitation of the system

The AEB is an assistant system for a driver in a certain risky driving condition and it does not take every responsibility for all risks from driving condition. The AEB monitors the driving situations through the radar. Thus, for a situation out of the sensing range, the AEB may not no ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Starting System

Description and operation Description The starting system consists of the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start posi ...