Kia Picanto: Front Door / Front Door Outside Handle

Kia Picanto JA 2017-2024 Service & Repair Manual / Body (Interior and Exterior) / Front Door / Front Door Outside Handle

Components and components location

Component Location

1. Front door outside handle

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

2.	Remove the door pull handle mounting support (A) after loosening the screws.

3.	Disconnect the front door speaker connector (A), and then remove the wiring mounting clips.

4.	Remove the front door trim seal (A).

5.	Disconnect the door lock rod (A).

6.	Disconnect the front door outside handle connector (A).

7.	Remove the plug hole cap (B) and then loosen the bolt and remove the door lock assembly (A).

8.	Remove the front door outside handle (A) by sliding it rearward.

Install in the reverse order of removal.

•	Be sure to install the outside handle pad (A) between the outside handle and the door panel.

•	Make sure that the connector is connected properly.

•	Make sure that the door locks/unlocks and opens/closes properly.

Front Door Power Window Regulator

Components and components location Component Location 1. Front door window glass Repair procedures Replacement Put on gloves to protect your hand ...

Front Door Latch

Components and components location Component Location 1. Front door latch Repair procedures Replacement Put on gloves to protect your hands. ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Front Seat Cushion Cover

Components and components location Component Location 1. Front seat cushion cover ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Air Cleaner

Components and components location Components 1. Air duct 2. Air cleaner assembly 3. Air intake hose Repair procedures Removal and Installation Air Cleaner Assembly 1. Unfasten the air intake hose clamp (A). Tightening torque : 2.9 - 4.9 N·m (0 ...