Kia Picanto: Brake system / ESS : Emergency Stop Signal
The Emergency Stop Signal system
alerts the driver behind by blinking the
stop light when the vehicle suddenly
stops or when the ABS activates in a
stop. (The system activates when the
vehicle speed is over 55km/h and the
vehicle deceleration is over 7m/s² or the
ABS activates when the vehicle emergency
braking.)
When the vehicle speed is under
40 km/h and the ABS deactivates or
the sudden stop situation is over, the
stop light blinking will stop.
CAUTION
The Emergency Stop Signal system
will not work if the hazard warning
flasher is already on.
This system provides further enhancements
to vehicle stability and steering
responses when a vehicle is driving on a
slippery road or a vehicle detected
changes in coefficient of friction betw ...
WARNING
Whenever leaving vehicle or parking,
always set the parking brake
as far as possible and fully engage
the vehicle's transaxle into the
park position. Vehicles not fully engaged ...
Other information:
Repair procedures
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
When using an impact gun, final tightening torque should be checked using a torqu ...
The driver can set the TPMS by following
procedures below:
1. Inflate all tires to the recommended
pressure.
2. Start the engine, make sure the vehicle
is not moving, and press the
TPMS switch (2) left side on the
driver’s seat for over 3 seconds.
3. Check if the () warning
indicato ...