Kia Picanto: Driveshaft and axle
Kia Picanto JA 2017-2024 Service & Repair Manual / Driveshaft and axle
Specifications
| Specification |
|
Engine
|
T/M
|
Joint type
|
Max. permissible angle
| ||
|
Outer
|
Inner
|
Outer
|
Inner
| ||
| Kappa 1.0 MPI | MT | BJ#21 | TJi#20 | 46.5° | 23° |
| Kappa 1.0 MPI | AT | BJ#20 | TJi#20 | 46.5° | 23° |
| Kappa 1.0 FFV | MT | BJ#21 | TJi#21 | 46.5° | 23° |
| Kappa 1.0 FFV | AT | BJ#20 | TJi#20 | 46.5° | 23° |
| Kappa 1.0 T-GDI | MT, AT | BJ#22 | TJi#22 | 46.5° | 23° |
| Kappa 1.2 MPI | MT | BJ#21 | TJi#21 | 46.5° | 23° |
| Kappa 1.2 MPI | AT | BJ#22 | TJ#20 | 46.5° | 23° |
| Tightening torque |
|
Item
|
N·m
|
kgf·m
|
lb·ft
| |
| Front | Tire wheel hub nuts | 107.9 - 127.5 | 11.0 - 13.0 | 79.6 - 94.0 |
| Driveshaft caulking nut | 274.6 - 294.2 | 28.0 - 30.0 | 202.5 - 217.0 | |
| Strut assembly to knuckle | 98.1 - 117.7 | 10.0 - 12.0 | 72.3 - 86.8 | |
| Lower arm to knuckle | 58.8 - 70.6 | 6.0 - 7.2 | 43.4 - 52.1 | |
| Tie rod end ball joint nut | 24.5 - 34.3 | 2.5 - 3.5 | 18.1 - 25.3 | |
| Front caliper to knuckle | 78.4 - 98.0 | 8.0 - 10.0 | 57.8 - 72.3 | |
| Front disc fixing screw | 4.9 - 5.9 | 0.5 - 0.6 | 3.6 - 4.3 | |
| Wheel speed sensor mount bolt | 6.9 - 10.8 | 0.7 - 1.1 | 5.1 - 8.0 | |
| Rear | Tire wheel hub nuts | 107.9 - 127.5 | 11.0 - 13.0 | 79.6 - 94.0 |
| Rear caliper to torsion beam axle | 63.7 - 73.5 | 6.5 - 7.5 | 47.0 - 54.0 | |
| Rear herb bearing to torsion beam axle | 49.0 - 58.8 | 5.0 - 6.0 | 236.1 - 43.3 | |
| Rear disc fixing screw | 4.9 - 5.9 | 0.5 - 0.6 | 3.6 - 4.3 | |
| Lubricants |
|
Engine
|
T/M
|
Joint
|
Lubricants
|
Quantity
|
| Kappa 1.0 MPI, FFV | MT | BJ | RBA | 90 - 100 g |
| TJi | CW-13TJ | 90 - 100 g | ||
| Kappa 1.0 MPI, FFV | AT | BJ | RBA | 60 - 70 g |
| TJi | CW-13TJ | 90 - 100 g | ||
| Kappa 1.0 T-GDI | MT | BJ | RBA | 90 - 100 g |
| TJi | CW09-VX21 | 135 - 145 g | ||
| Kappa 1.0 T-GDI | AT | BJ | RBA | 90 - 100 g |
| TJi | CW-13TJ | 135 - 145 g | ||
| Kappa 1.2 MPI | MT | BJ | RBA | 90 - 100 g |
| TJi | CW-13TJ | 110 - 120 g | ||
| Kappa 1.2 MPI | AT | BJ | RBA | 90 - 100 g |
| TJi | CW-13TJ | 90 - 100 g |
Special service tools
| Special Service Tools |
|
Tool Name / Number
|
Illustration
|
Description
|
| Lower arm ball joint remover 0K545-A9100 |
| Used for removing the ball joint |
| Ball joint puller 09568-1S100 |
| Remove the ball joint |
| Band installer 09495-3K000 |
| Used for installing ear type boot band |
| Band installer 09495-39100 |
| Used for installing huke type boot band |
Troubleshooting
| Troubleshooting |
|
Trouble Symptom
|
Probable cause
|
Remedy
|
| Vehicle pulls to one side | Scoring of driveshaft ball joint | Replace |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Defective front suspension and steering | Adjustment or Replace | |
| Vibration | Wear, damage or bending of driveshaft | Replace |
| Driveshaft rattle and hub serration | Replace | |
| Wear, rattle or scratching of wheel bearing | Replace | |
| Shimmy | Defective wheel balance | Adjustment or Replace |
| Defective front suspension and steering | Adjustment or Replace | |
| Excessive noise | Wear, damage or bending of driveshaft | Replace |
| Rattle of driveshaft and worn hub splines | Replace | |
| Wear, rattle or scoring of wheel bearing | Replace | |
| Loose hub nut | Adjustment or Replace | |
| Defective front suspension and steering | Adjustment or Replace |
Neutral Switch
Specifications
Specifications
Item
Specified
Type ON / OFF Operating condition Neutral gear Operating voltage 10 V - 15 V Oper ...
Front Axle Assembly
Components and components location
Components
1. Snap ring 2. Bearing 3. Axle assembly 4. Brake disc dust cover 5. Wheel hub assembly 6. Wheel brake disc 7. Brake disc fixing screw 8. Wheel ...
Other information:
Kia Picanto JA 2017-2024 Service & Repair Manual: Severe Condition
General market Maintenance Under Severe Usage Conditions - For Gasoline Engine [Except Europe (Including Russia)] MAINTENANCE ITEM MAINTENANCE OPERATION MAINTENANCE ...
Kia Picanto JA 2017-2024 Owner's Manual: Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil and filter changes are required. Drive belts Inspect all drive belts for evidence of cuts, c ...
Copyright © www.kpicanto.com 2017-2024
