Kia Picanto (JA): SRSCM / Seat Belt Buckle Switch (BS)

Kia Picanto (JA) 2017-2026 Service & Repair Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS)

Description and operation

Description

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Components and components location

Components

1. Seat Belt Buckle Switch (BS)

Repair procedures

Removal

1.	Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.	Remove the front seat assembly. (Refer to the Body - "Front Seat Assembly")

3.	Loosen the mouting bolt and then remove the seat belt buckle switch (A).

Installation

1.	Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.	Install in the reverse order of removal.

3.	Reconnect the battery negative terminal.

After installing the seat belt buckle switch, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

❮Side Impact Sensor (SIS)

Description and operation Description • Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) installed at each center of the front door module (LH and RH), two SIS installed at each center pillar nearby (LH and RH) and two rear SIS installed in the rear pillar (LH and RH).

Airbag Module❯

Other information:

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Combination Lamp

Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the rear combination lamp (A) after loosening the screws. 3.Remove the rear combination lamp packing (A). 4.Disconnect the rear combination lamp connector (A).

Kia Picanto (JA) 2017-2026 Service & Repair Manual: Rear Glass Defogger Printed Heater

Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.