Kia Picanto: Roof Trim / Roof Trim Assembly

Kia Picanto JA 2017-2023 Service & Repair Manual / Body (Interior and Exterior) / Roof Trim / Roof Trim Assembly

Components and components location
Component Location

1. Roof Trim Assembly


Repair procedures
Replacement
   
Put on gloves to protect your hands.
   
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.
1.
Remove the front seat.
(Rear to Front Seat - "Front Seat Assembly")
2.
Remove the rear seat assembly.
(Rear to Rear Seat - "Rear Seat Assembly")
3.
Remove the front pillar trim.
(Rear to Interior Trim - "Front Pillar Trim")
4.
Remove the center pillar upper trim.
(Rear to Interior Trim - "Center Pillar Trim")
5.
Remove the rear pillar trim.
(Rear to Interior Trim - "Rear Pillar Trim")
6.
Remove the sun visor and retainer.
(Rear to Roof Trim - "Sun visor")
7.
Remove the assist handle.
(Rear to Roof Trim - "Assist Handle")
8.
Remove the overhead console lamp.
(Rear to Body Electrical System - "Map Lamp")
9.
Remove the ECM mirror cover (A).

10.
Disconnect the connector (A).

11.
Disconnect the roof trim main connector (A) and the mounting clips in the front pillar.
[Passenger side]

12.
Disconnect the wiring connector (A).

13.
Remove the roof trim assembly (A) from the vehicle through the tailgate.
   
Be careful not to damage the roof trim during removal.

   
1)
Apply the hot melt continuously when installing the roof trim wiring harness (A) on the roof trim (B) using the hot melt gun tool.
2)
Put anti-noise pad on roof trim (B) to prevent the noise.
14.
Install in the reverse order of removal.
   
Make sure the connector is plugged in properly.
Replace any damaged clips.
Assist Handle
Components and components location Component Location 1. Assist handle Repair procedures Replacement    Put on gloves to protect your hands. ...

Tailgate
Repair procedures Adjustment 1. After loosening the tailgate hinge (A) mounting bolts, adjust the tailgate by moving it up and down, or right and left. 2. Adjust the tailgate height by turning ...

Other information:

Kia Picanto JA 2017-2023 Service & Repair Manual: Blower Unit


Components and components location Component Location 1. Blower Unit Components 1. Intake Actuator 2. Intake Case [Lower] 3. Air Filter 4. FET 5. Resister 6. Intake Seal 7. Intake Case [Upper] 8. Intake Door Assembly 9. Anti Noise Pad 10. Air Filter Cover 11. Blower Case [Upper] 12. ...

Kia Picanto JA 2017-2023 Service & Repair Manual: Assist Handle


Components and components location Component Location 1. Assist handle Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove inter ...

Copyright © www.kpicanto.com 2017-2023