Kia Picanto: Cooling System / Reservoir Tank

Kia Picanto JA 2017-2025 Service & Repair Manual / Engine Mechanical System / Cooling System / Reservoir Tank

Components and components location
Components

1. Reservoir tank
2. Reservoir hose & pipe
3. Turbo charger water drain hose
4. Water return hose

Repair procedures
Removal and Installation
1.
Disconnect the reservoir hose (A), and then drain the coolant from the reservoir tank.
2.
Disconnect the water return hose (B) and turbo charger water drain hose (C).

3.
Remove the reservoir tank (B).
Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 Ib·ft)

4.
Install in the reverse order of removal.
5.
Fill with engine coolant.
Coolant
Repair procedures Replacement and air bleeding    Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...

Cooling Fan
Components and components location Components 1. Cooling fan 3. Cooling fan motor 3. Cooling fan shroud Specifications Specifications Item ...

Other information:

Kia Picanto JA 2017-2025 Owner's Manual: Condition of ISG system operation


The ISG system will operate under the following condition: - The driver’s seat belt is fastened. - The driver’s door and hood are closed. - The brake vacuum pressure is adequate. - The battery is sufficiently charged. - The outside temperature is more than -2°C (28.4°F). - The o ...

Kia Picanto JA 2017-2025 Owner's Manual: Distributing the sealant


12. Immediately drive approximately 7~10 km (4~6 miles or, about 10 min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 miles). If possible, do not fall below a speed of 20 km/h (12 miles). While driving, if you experience any unusual vib ...

Copyright © www.kpicanto.com 2017-2025