Kia Picanto: Rear Wiper/Washer / Rear Washer Switch
Repair procedures
Multifunction Switch Inspection
1. | Check for continuity between the terminals in each switch position as shown below.
 Rear Wiper & Washer Switch [LHD]
 [RHD]
 |
Inspection (With KDS/GDS)
1. | In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS). The diagnostic system(KDS/GDS) provides the following information. (1) | Self diagnosis : Checking failure and code number (DTC) |
(2) | Current data : Checking the system input/output data state |
(3) | Actuation test : Checking the system operation condition |
(4) | Additional function : Controlling other features including system option setting and zero point adjustment |
|
2. | Select the 'Car model' and the 'Body Control Module (BCM)' to be checked in order to check the vehicle with the tester. |
3. | Select the 'Current Data' menu to search the current state of the input/output data.
 |
Repair procedures
Inspection
Rear Wiper Motor
1.Remove the connector from the rear wiper motor.
2.Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal ...
Repair procedures
Inspection
1.With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before
filling the reservoir tank with water, ch ...
Other information:
The driver can set the TPMS by following
procedures below:
1. Inflate all tires to the recommended
pressure.
2. Start the engine, make sure the vehicle
is not moving, and press the
TPMS switch (2) left side on the
driver’s seat for over 3 seconds.
3. Check if the () warning
indicato ...
The rear window wiper and washer
switch is located at the end of the wiper
and washer switch lever. Turn the
switch to desired position to operate
the rear wiper and washer.
6. Rear window washer
7. Intermittent wipe
8. Wiper is not in operation
Turn the wiper lever switch upwards ...