Kia Picanto: Body Electrical System / Back View Camera System

Kia Picanto JA 2017-2025 Service & Repair Manual / Body Electrical System / Back View Camera System

Components and components location

Component Location

1. Back view camera
2. AVN head unit

3. steering angle sensor

Description and operation

Description

1.	To display back of the vehicle to assist the driver, it receives vehicle rearside image signal from the rearview camera and displays it on AVN head unit monitor or LHS of inside rearview mirror.

2.	Back view camera is a supplementary device that displays dead zone on monitor screen that automatically operates when the gear stays in "R" for over 3 seconds.

3.	It displays the estimated trajectory with parking guideline in accordance with the operating angle of steering wheel. (There is no separate unit.)

System Structure (Back view camera operated by steering)

Schematic diagrams

Circuit Diagram

Repair procedures

Removal

In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

3.	Disconnect the tailgate outside handle assembly connector (A).

4.	Remove the tailgate outside handle assembly (A) after loosening the mounting nuts.

5.	Disconnect the tailgate open switch connector (A).

6.	Remove the back view camera assembly (A) after loosening the mounting screws.

Installation

1.	Install the back view camera assembly.

2.	Connect the tailgate open switch connector.

3.	Install the tailgate outside handle assembly.

4.	Connect the tailgate outside handle assembly connector.

5.	Install the tailgate trim.

6.	Connect the negative (-) battery terminal.

Mic

Repair procedures Inspection 1.Disconnect the negative (-) battery terminal. 2.Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3.Remove the hands free m ...

Body Control Module (BCM)

Specifications Specifications [BCM Type] Items Specifications Rated voltage DC 12 V Operating voltage DC 9 - 16 V Operating ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Intake Actuator

Components and components location Component Location 1. Intake Actuator Description and operation Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will ...

Kia Picanto JA 2017-2025 Service & Repair Manual: Multifunction Switch

Specifications Specifications Items Specifications Rated voltage DC 12 V Operating temperature range -22 - 176°F (-30 - 80°C) Rated load Washer Washer : 6A (Motor load) Components and components location Compone ...