Operates as follows when the ignition switch is turned ON.
1 2/HI : Fast wiper speed
2 1/LO : Normal wiper speed
3 ---/INT :
Wiper operates intermittently
at the same wiping
intervals. Use this mode in
light rain or mist. To vary
the speed setting, turn
the speed control knob.
4 O/OFF : Wiper is not in operation
5 ˅/1X : For a single wiping cycle,
move the lever to this position
and release it. The
wipers will operate continuously
if the lever is held
in this position.
NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wiper and washer, it may damage the wiper and washer system.
A : Wiper speed control (front) 1. 2/HI – High wiper speed 2. 1/LO – Low wiper speed 3. ---/INT – Intermittent wipe 4. O/OFF – Off 5.
In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty.
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.
Components and components location Component Location 1. Mode Control Actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit.