Other information:
Repair procedures
Removal
1.Disconnect the negative (-) battery terminal.
2.Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a bolt.
Repair procedures
Inspection
Multifunction Switch Inspection
1. Check for continuity between the terminals in each switch position as shown below.
Rear Wiper & Washer Switch[LHD]
[RHD]
Inspection (With KDS/GDS)
1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).