Kia Picanto (JA): Rear Wiper/Washer / Rear Washer Motor

Repair procedures

Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
   
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Remove the engine room under cover.
G 1.0 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")
G 1.2 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")
3.
Remove the front wheel guard [RH].
(Refer to Body - "Front Wheel Guard")
4.
Connect positive (+) battery cables to terminal 3 and negative (-) battery cables to terminal 2 respectively.
5.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
6.
If they are abnormal, replace the washer motor.
[Front & Rear washer]
No.
Description
1
Front windshield washer (+)
2
Ground
3
Rear washer (+)

    Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below.

    Other information:

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Power Door Locks

    Components and components location Component Location 1. Driver power window switch 2. Assist power window switch 3 . Body Comtrol Module (BCM) 4 . Door lock knob 5 . Tailgate actuator 6. Door latch lock actuator 7 . Door lock/unlock switch 8 .

    Kia Picanto (JA) 2017-2026 Service & Repair Manual: Smart Key Unit

    Components and components location Components Connector Pin Information No. Connector A Connector B Connector C 1 - IGN2 Relay_output Battery (+)_Signal 2 SSB Switch1 signal_input P-CAN (Low) - 3 Driver door o

    Categories

     
    Copyright © 2026 www.kpicanto.com - 0.0307